Mitsubishi Electric Q13UDVCPU - Page 578

576
(17)iQ Sensor Solution
Number Name Meaning Explanation
Set by
(When Set)
Corresponding
ACPU
D9
Corresponding
CPU
SD1435
Use request (iQ
Sensor Solution
backup/restoration)
Requests the use
of the
backup/restoration
function.
This register is used to acquire a right to use the
backup/restoration function before its execution.
A four-digit number (other than request number
0000
H
) shall be set.
The number is determined according to the
request source.
1***
H
: when requested using a ladder program
D***
H
: when requested from MELSOFT
Navigator
E***
H
: when requested from GOT
F***
H
: when requested from GX Works2
• A value is cleared to "0" when the right is lost.
S (Status
change)/U
New
QnUDV
*1
LCPU
*2
SD1436
Right acquisition
status (iQ Sensor
Solution
backup/restoration)
Stores the request
source that has
acquired a right to
use the
backup/restoration
function.
This register stores the request source that has
acquired a right to use the backup/restoration
function.
• A value is cleared to "0" when the right is lost.
S (Status
change)
New
QnUDV
*1
LCPU
*2
SD1437
Target
module/execution
unit setting (iQ
Sensor Solution
backup/restoration)
Sets the target
module and
execution unit for
backup/restoration.
This register is used to set the target module
and execution unit for backup/restoration.
Lower 8 bits (target module)
1
H
: AnyWireASLINK
2
H
: CC-Link
3
H
: Ethernet
4
H
: CC-Link IE Field Network
Upper 8 bits (execution unit)
[AnyWireASLINK]
1
H
: Module
2
H
: ID
[CC-Link, CC-Link IE Field Network]
1
H
: Module
2
H
: Station
3
H
: Station sub-ID
[Ethernet]
1
H
: Module
2
H
: IP address
UNew
QnUDV
*1
LCPU
*2
SD1438
Folder number
setting (iQ Sensor
Solution
backup/restoration)
Sets the folder
number for
backup/restoration.
This register is used to set a number of a folder
in which backup data is to be stored or a folder
that contains data for restoration.
0 to 99: Folder number specification
FFFE
H
: Automatic specification (folder deletion
supported)
FFFF
H
(default): Automatic specification
UNew
QnUDV
*1
LCPU
*2
SD1439
Target module
setting (iQ Sensor
Solution
backup/restoration)
Sets a module
targeted for
backup/restoration.
This register is used to set a module targeted for
backup/restoration.
I/O No.: Module (Enter the value obtained by
dividing the start I/O number by 16.)
3FF
H
: Built-in Ethernet
UNew
QnUDV
*1
LCPU
*2
SD1440
Target device 1
setting (iQ Sensor
Solution
backup/restoration)
Sets devices
targeted for
backup/restoration.
This register is used to set a device targeted for
backup/restoration.
[AnyWireASLINK]
ID number
[CC-Link, CC-Link IE Field Network]
Station number
[Ethernet]
IP address (lower 16 bits)
(Example) If the IP address is 192.168.3.40, 3
equals to 3
H
and 40 equals to 28
H
.
The stored value will be 0328
H
, that is, 808.
UNew
QnUDV
*1
LCPU
*2