20
2.3 PERIPHERAL I/F Connector
The specifications of the PERIPHERAL I/F connector are shown below.
Only a LAN connection is available for PERIPHERAL I/F connector. Connection via
the Internet is not possible.
Corresponding Ethernet cables
The specifications of Ethernet cables used for connecting to the PERIPHERAL I/F connector
are shown below.
Selection criterion of cable
• Category
5 or higher
• Diameter of lead
AWG26 or higher
•Shield
Copper braid shield and drain wire
Copper braid shield and aluminium layered type shield
Item Specification
Transmission Data transmission speed 100Mbps/10Mbps
Communication mode Full-duplex/Half-duplex
Transmission method Base band
Cable length [m(ft.)] Up to 30 (98.43)
Connection type Cable type Ethernet standard Module name
Connection with HUB Straight cable 10BASE-T Compliant with Ethernet standards, category
5 or higher.
• Shielded twisted pair cable (STP cable)
100BASE-TX
Direct connection • Crossover cable
• Straight cable
10BASE-T
100BASE-TX
To Next Page
Loading...
