Mitsubishi Electric Q170MSCPU - Page 24

23
Motion controller mounting position
Keep the clearances shown below between the top/bottom faces of the module and other
structures or parts to ensure good ventilation and facilitate module replacement.
*1 Fit the Motion controller at the left side of the servo amplifier.
Servo amplifier
30mm (1.18inch) or more
30mm (1.18inch)
or more
10mm (0.39inch) or more
Motion
controller
*1
Extension
cable
Top of panel or wiring duct
100mm
(3.94inch)
or more
Panel
Door
40mm(1.57inch)
or more
70mm(2.76inch)
or more