28
Mounting procedure
1. Anchor the lead wire to the lead
wire fixing hook. (1)
2. Connect the battery lead
connector to the battery
connector. (2)
3. Adjust the battery holder to the
installation grooves, and slide
the battery holder in the
direction of the arrow, taking
care to not damage the lead
wires. (Be sure to insert it until it
clicks.) (3)
4. Make sure that the battery
holder is installed in the Motion
controller securely.
Battery holder
Lead wire fixing
hook
Battery connector
(Q170MSCPU side)
Battery lead
connector
(Battery side)
Motion controller
(1)
(2)
Battery holder
Installation grooves
Push
(3)
To Next Page
Loading...
