Mitsubishi Electric Q170MSCPU - Page 7

6
CAUTION
 When transporting the Motion controller or servo amplifier, never hold the front case as it
may fall off.
 When transporting, installing or removing the Motion controller or servo amplifier, never
hold the edges.
 Install the unit according to the instruction manual in a place where the mass can be
withstood.
 Do not get on or place heavy objects on the product.
 Always observe the installation direction.
 Keep the designated clearance between the Motion controller or servo amplifier and
control panel inner surface or the Motion controller and servo amplifier, Motion controller or
servo amplifier and other devices.
 Do not install or operate Motion controller, servo amplifiers or servo motors that are
damaged or that have missing parts.
 Do not block the intake/outtake ports of the Motion controller, servo amplifier and servo
motor with cooling fan.
 Do not allow conductive matter such as screw or cutting chips or combustible matter such
as oil enter the Motion controller, servo amplifier or servo motor.
 The Motion controller, servo amplifier and servo motor are precision machines, so do not
drop or apply strong impacts on them.
 Securely fix the Motion controller, servo amplifier and servo motor to the machine
according to the instruction manual. If the fixing is insufficient, these may come off during
operation.
 Always install the servo motor with reduction gears in the designated direction. Failing to
do so may lead to oil leaks.
 Use the Motion controller in an environment that meets the general specifications
contained in this manual (Page 14 General Specifications). Using this Motion
controller in an environment outside the range of the general specifications could result in
electric shock, fire, operation failure, or damage to or deterioration of the product.
 When coupling with the synchronous encoder or servo motor shaft end, do not apply
impact such as by hitting with a hammer. Doing so may lead to detector damage.
 Do not apply a load larger than the tolerable load onto the synchronous encoder and servo
motor shaft. Doing so may lead to shaft breakage.
 When not using the module for a long time, disconnect the power line from the Motion
controller or servo amplifier.
 Place the Motion controller and servo amplifier in static electricity preventing vinyl bags
and store.
 When storing for a long time, please contact with our sales representative.
Also, execute a trial operation.
 When fumigants that contain halogen materials such as fluorine, chlorine, bromine, and
iodine are used for disinfecting and protecting wooden packaging from insects, they cause
malfunction when entering our products.
Please take necessary precautions to ensure that remaining materials from fumigant do
not enter our products, or treat packaging with methods other than fumigation (heat
method).
Additionally, disinfect and protect wood from insects before packing products.