Mitsubishi Electric QJ71MES96N - Battery; Battery Specifications; Mounting of Battery

4
SETTINGS AND PROCEDURE TO OPERATION
4.8 Battery
4.8.1 Battery specifications
4 - 20
1
OVERVIEW
2
SYSTEM CONFIGURATION
3
SPECIFICATIONS
4
SETTINGS AND PROCEDURE TO OPERATION
5
INSTALLATION AND UNINSTALLATION
6
FUNCTIONS
7
MES INTERFACE FUNCTION CONFIGURATION TOOL
8
DB CONNECTION SERVICE AND SETTING TOOL
4.8 Battery
This section explains the mounting and replacement of the battery.
4.8.1 Battery specifications
This section shows the specifications of the QJ71MES96 MES interface module battery.
*1 The lithium content of batteries manufactured in July 2017 or earlier differs from this list. For
details, refer to the following.
Technical bulletin No. FA-A-0242
Remark
For the battery directive in EU member states, refer to Appendix 9.
4.8.2 Mounting of battery
The QJ71MES96 MES interface module is shipped with the battery connector
disconnected. Before using the module, connect the battery connector.
• Firmly push the battery connector all the way in to the connector pin.
• When operating without battery mounted, refer to the following.
Section 4.9 Operation without Mounting Battery
Not following the procedure may cause the data corruption in the
CompactFlash card being accessed or a file system error.
Table 4.9 Battery specifications
Item
Description
Q6BAT
Type Manganese dioxide lithium primary battery
Initial voltage 3.0 V
Nominal current 1800 mAh
Battery life when stored Actual life of 5 years (room temperature)
Battery life when used
Section 4.8.3 Battery replacement
Lithium content
0.57 g
*1
Application File protection
1 Open the battery cover located on the bottom of the module.
2 Check that the Q6BAT is correctly installed.
3 Check the direction and securely insert the connector plug of the Q6BAT
to the jack of the module.
4 Close the battery cover.
MES interface module
Battery
Connector
Connector fixing