OIL PAN AND OIL PUMP
ENGINE OVERHAUL <4G63-Turbo>
11D-51
>>I<< FLANGE BOLT INSTALLATION
1. Insert a correspond screwdriver (shank diameter
8 mm) into the hole in the left side of the cylinder
block to prevent the counterbalancer shaft from
rotating.
2. Tighten the flange bolts.
>>J<< PLUG INSTALLATION
1. Install a new O-ring on the front case.
2. Use the special tools to tighten the plug to the
specified torque.
• Plug wrench (MD998162)
• Plug wrench retainer (MD998783)
>>K<< OIL PRESSURE SWITCH
INSTALLATION
CAUTION
Be careful not to block the oil passage with seal-
ant.
1. Apply sealant to the threaded portion.
Specified Sealant:
3M ATD Part No.8660 or equivalent
2. Tighten the oil pressure switch together with the
cylinder block by the specified torque using of the
special tool Oil pressure switch wrench
MD998054.
Tightening torque: 19 ± 3 N⋅m
AK300172
AK300183
AK300184
MD998162
MD998783
AD
AK300715
AB
AK204037
AD
MD998054
To Next Page
Loading...
