Mitsubishi 4g63 - Oil Pan and Oil Pump - Part 7; Oil Pan Upper;Lower Installation

OIL PAN AND OIL PUMP
ENGINE OVERHAUL <4G63-Turbo>
11D-52
>>L<< OIL PAN UPPER/OIL PAN LOWER
INSTALLATION
CAUTION
Do not apply FIPG over remaining old FIPG.
Doing so could result in oil leakage.
1. Clean the gasket surfaces of the cylinder block
and oil pan.
CAUTION
Too much FIPG will squeeze out, blocking cool-
ant or oil passages, while too thin a bead could
result in leakage.
2. Apply a 4 mm diameter bead of FIPG to the flange
surface all around the oil pan.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
NOTE: In the grooved areas on the oil pan flange,
apply FIPG bead along the center of the groove.
3. Install the shorter bolts in the locations indicated
in the drawing.
CAUTION
Do not apply FIPG over remaining old FIPG.
Doing so could result in oil leakage.
4. Thoroughly remove old FIPG from the gasket
surfaces of the oil pan upper and lower sections.
CAUTION
Too much FIPG will squeeze out, blocking cool-
ant or oil passages, while too thin a bead could
result in leakage.
5. Apply a 4 mm diameter bead of FIPG to the flange
surface all around the oil pan.
Specified sealant:
Mitsubishi Genuine Part No.MD970389 or
equivalent
NOTE: In the grooved areas on the oil pan flange,
apply FIPG bead along the center of the groove.
6. Install the oil pan lower section by tightening the
bolts in the indicated sequence.
AK304401
Timing belt side
Bolt hole
area
Grooved
area
AB
AK304402
AB
M6 × 16
AK304403
Timing belt side
Bolt hole
area
Grooved area
AB
AK304404
Timing belt side
1
2
3
5
6
9
10
11
12
7
4
AB
8