WARNING
l
Hard engine braking can cause the tyres
to slip on the road surface, possibly lead-
ing to a serious accident.
Waiting
E00613300059
1. With the allshift lever in the “S” (Stand by)
position, firmly depress the brake pedal.
2. If necessary, apply the parking brake.
CAUTION
l
On an uphill slope, the transmission’s
creep effect may not stop the vehicle from
rolling backward if the brakes are not ap-
plied. There is no creep effect while
2
nd
gear is selected. When stopping, be
sure to depress the brake pedal and se-
curely apply the parking brake.
l
Do not attempt to hold the vehicle in
place on an uphill road in 1
st
gear by de-
pressing on the accelerator pedal. The
transmission could malfunction if you do.
3. When you are stationary for a long period
(for example, when stuck in a traffic jam),
place the allshift lever in the “N” (Neutral)
position.
CAUTION
l
Continue to pay attention to the vehicle
while stationary. If you allow your atten-
tion to wander and the allshift lever is in
any position other than “N” (Neutral),
the vehicle could move suddenly and un-
expectedly.
4. When you are ready to start moving again,
first confirm that the allshift lever is in the
“S” (Stand by) position or “R” (Reverse) po-
sition and that an “A”, “1”, or “R” is shown
on the multi-information display.
NOTE
l
During vehicle operation, the transmission au-
tomatically shifts down when the vehicle
speed decreases. It selects 1
st
gear just before
the vehicle reaches a standstill.
CAUTION
l
The actions described below cause rapid
clutch wear and can cause clutch dam-
age. Do not perform them.
• Depressing the brake and accelerator
pedals at the same time.
• Holding the vehicle in place on an up-
hill road by depressing the accelerator
pedal (and not depressing the brake
pedal) with 1
st
gear selected.
Parking
E00613400034
1. Bring the vehicle to a complete stop.
2. While depressing the brake pedal, securely
apply the parking brake.
3. Move the allshift lever into the “S” (Stand
by) position when parking on an uphill
grade, into the “R” (Reverse) position when
parking on a downhill grade. And confirm
that there is an “A”, “1” or “R” in the multi-
information display.