3. Undo the clips (D) (6 locations) one by one,
starting at the top and finishing at the bot-
tom. (Pull each clip in the direction of the ar-
row to undo it.) Then, remove the bulb holder.
4. Remove the bulb by turning it anticlockwise
while pressing in (except for stop lamp) or
by pulling out (stop lamp).
E- Stop lamp
F- Rear turn-signal lamp
G- Tail lamp
H- Rear fog lamp (driver’s side)
Reversing lamp (passenger’s side)
5. To install the bulb, perform the removal
steps in reverse.
NOTE
l
When mounting the lamp unit, align the pins
(I) on the lamp unit with the hole and the clip
in the body.
Reversing lamp (passenger’s side)/
Rear fog lamp (driver’s side)
E01004400228
3-door models
1. Press the tab (A) and remove the cover (B).
2.
Remove the socket and bulb assembly (C) to-
gether by turning it anticlockwise, and then
remove the bulb by turning it anticlockwise
while pressing in.
Maintenance
8-29
8
To Next Page
Loading...
