Mitsubishi FX Series User Manual

Use the manual Beichen Automation BCNET-FX-S Ethernet communication processor
Create Hot Password: module to create the AP Hot Password, up to 64 characters.
Create hotspot encryption mode: module to create the AP hotspot encryption
mode, support no password, WEP, WPA and WPA2 mode.
IP address of the AP: IP address of the AP hotspot, default 192.168.3.1.
Mask: The Mask Address for AP hotspots, default 255.255.255.0.
AP address pool range: the range of IP addresses that a module can provide when it is an AP
hotspot.
When you change the above parameters, click the [ confirm ] button. BCNET-FX-S
will reset and restart. Please go back to the address bar
Retype the new IP address to refresh the home page and see if the Ethernet
interface parameter settings are valid.
3.2.4 communications diagnostics
Serial Bus Communication
PLC-> total number of communication requests: number of all communication requests sent to
PLC;
Correct response times: the number of PLC correct responses to
these requests;
Error response times: the number of error responses sent by PLC;

Mitsubishi FX Series Specifications

General

Manufacturer	Mitsubishi Electric
Category	Programmable Logic Controller (PLC)
Series	FX Series
Programming Language	Ladder Logic, Instruction List, Structured Text, Function Block Diagram
Communication Interfaces	RS-422, RS-485, Ethernet, USB
Protocols Supported	Modbus RTU, Modbus TCP, CC-Link
Input Voltage	24 VDC, 100-240 VAC
Output Type	Relay, Transistor
Operating Temperature	0°C to 55°C