Mitsubishi FX Series - Communication Test Procedures

Use the manual Beichen Automation BCNET-FX-S Ethernet communication processor
The state of the WiFi interface is divided into AP (module as hotspot) and Station
(module connection hotspot)
AP (module as a hotspot) : Can View the module as the current AP hot operating parameters and
status;
Station (module connection hot spot) : Can View the current module connection hot spot operating
parameters and status;
3.3.5 communication test
Click on the communication test, click on the link, will cycle check, click
send, the correct number of times with the number of cumulative send test
success.