Use the manual Beichen Automation BCNET-FX-S Ethernet communication processor
Automatic Identification PLC model: recommended to open, so that the BCNet module can
automatically get the PLC model, and match the communication parameters
Number.
PLC model selection: when the automatic identification of the PLC model closed, you can manually select
the PLC type. If your PLC is
FX1S, Huichuan HNU series [ download/HMI monitoring protocol ] , you can manually set the PLC
model for FX1S, baud rate
Set at 9600.
Number of retries: number of communication retries.
PLC baud rate selection: baud rate can choose 9600,19200,38400,57600 and 115200 bps.
B) the extended bus interface (HMI) is used to configure the communication parameters between the
module and the HMI touch screen.
To Next Page
Loading...
