Use the manual Beichen Automation BCNET-FX-S Ethernet communication processor
Enable Station function: enable Station function, connect hot spots;
The name of the hotspot to be connected: the SSID name of the AP hotspot to be
connected by the module, which can support up to 32 characters;
Hot password to connect: module to connect the AP Hot Password, the maximum
support of 64 characters;
Hotspots authentication: module-connected AP hotspots encryption type, support no
password, WEP, WPA and WPA2, silent
WPA2 type;
Auto-get IP address: Static IP address of
module Station; IP address of Station:
Subnet Mask Address of module Station;
Subnet Mask of Station: Subnet Mask of
module creating AP hotspot;
Station Gateway Address: when the module creates AP hotspots, the IP address assignment range that
the module can provide;
3.3.4 equipment operation diagnosis
1. Click the [ device running diagnostics ] button, in the dialog box that pops up, you can view the [ diagnostic
information ] and [ WiFi interface
The director of environmental protection.
To Next Page
Loading...
