Mitsubishi FX Series - Station Mode: Connecting to Hotspots; Station Feature Configuration

Use the manual Beichen Automation BCNET-FX-S Ethernet communication processor
4.wi-fi application guide
BCNET-FX-S integrated WiFi function, BCNet-FX-S can achieve AP + STATION mode of work, the
following are introduced
This paper introduces the module as the configuration and application of AP
hotspot and Station mode.
4.1 Station (module connection hotspot)
When BCNET-FX-S connects AP hotspots, the module works in Station mode, which is suitable for
multi-equipment networking and centralized monitoring
Control and data acquisition; this approach requires a high-power and signal-stable AP
hotspot, the module will work in Station mode
And connected to the hot spot, the centralized monitoring of the LAN can be
realized;
4.1.1station feature configuration
1. Run“BCDevice” tool, as shown below to search the module, and enter the modified device
parameters interface;
2. In the“Station (module connection hotspots)” interface check the“Enable AP function, create
hotspots”;