Mitsubishi FX Series - GX Works2 Connection for FX1 N;FX2 N;FX1 S Series

Use the manual Beichen Automation BCNET-FX-S Ethernet communication processor
5.1.2 is suitable for FX1N/1NC, FX2N/2NC, FX1S, FX3G/3GS, FX3S,
FX2N/2NC
FX3U/3UC
Mode two applies to the full range of FXCPU, choose this mode mainly for FX1N,
FX2N, FX1S series
PLC used. The implementation of GX Works2 Ethernet connection FX2NC through BCNet-FX-S for
example, to illustrate the use of steps:
1. Create a new FX2N/FX2NC project and double-click the Connection target in the navigation
bar: Connection.
2. After the pop-up, double-click the“Ethernet board” option on the computer side, then click“Yes”
in the reminder;
Double-click“GOT” on the side of the programmable controller;