FX
1N
SERIES PROGRAMMING CAUTION
Thank you for buying The Mitsubishi FX
1N
series controller.
Please note the following.
Notes: Block Move instruction
Applicable PLC: FX
1N
Ver 1.00-2.10
Applicable instructions: BMOV, BMOVP(FNC15)
If the file register parameter setting and the registers D8000-D8225 are used as the
destination devices for the BMOV(BMOVP) instruction, program steps or file register data may
be lost or damaged. All other data registers can be used safely for BMOV(BMOVP) instruction
destination registers.
Program example
BMOV D8140 K2
(S·) (D·) n
M8002
DMOV D8140
(S·) (D·)
M8002
Problem OK
D D
To Next Page
Loading...
Need help?
General
