REASSEMBLY OF BASIC ENGINE
7-16
3.3 Installing flywheel
&$87,21
The person who holds the pulley must be very careful
to assure safety by communicating with the person
who is installing the flywheel.
(1) One person must firmly hold the pulley with a wrench
to prevent the crankshaft from turning.
(2) Screw the guide bolt into the rear end of the crankshaft.
(3) Align the bolt hole of flywheel with the guide bolt and
install the flywheel to the crankshaft.
(4) Temporarily tighten bolts.
(5) Remove the guide bolt and temporarily tighten the last
bolt.
(6) Tighten the flywheel bolts to the specified torque.
Detent of flywheel
Installing flywheel
Tightening flywheel bolts
Prevent the flywheel from rotating
using a wrench.
Guide bolt
(M101.25mm)
Tightening torque
83.4 to 93.2N㨯m
{8.5 to 9.5kgf㨯m}
[61.5 to 68.7lbf㨯ft]
To Next Page
Loading...
Need help?
General
