SIDE SILL
WELDED PANEL REPLACEMENT
3-22
3. Cut the side sill reinforcement support 50mm (1.97 in)
forward of the cut area of the side sill outer reinforcement
center.
4. Adhere in advance adhesives in the areas shown in the
figure of the instructions when assembling the side sill outer
reinforcement.
5. After assembling the new parts to the body, weld the side sill
reinforcement support, then weld the part cut from the side
sill outer reinforcement center.
6. Apply in advance body sealant in the areas shown in the
figure of the instructions when assembling the side outer
panel.
7. Assemble the side outer panel, then bolt and tape the hole
and flange with aluminum tape and fill the hole with foam
materials as shown in the figure of the instructions.
FOAM: 3Mä Super panel filler
ADHESIVE TYPE BRAND
Epoxyayresin
adhesive
3Mä Part No.8115 or
equivalent
AB200601
AB
50 mm (1.97 in)
SIDE SILL REINFORCEMENT SUPPORT
AB200626
: ADHESIVE
AB
AB200602
AB100199
AC
: BODY SEALANT
Y0352AV
AB202328
AB
To Next Page
Loading...
Need help?
General
