CAUTION
l
The customer is responsible for making
sure that periodic inspection and mainte-
nance are performed. Inspections and
maintenance must be performed to pre-
vent accidents and malfunctions.
NOTE
l
“---”
display cannot be reset when the igni-
tion switch is “ON”.
l
When
“---” is displayed, after a certain dis-
tance and a certain period of time, the dis-
play is reset and the time until the next peri-
odic inspection is displayed.
l
If you accidentally reset the display, we rec-
ommend you to consult a MITSUBISHI
MOTORS Authorized Service Point.
Door ajar warning display screen
(when the ignition switch is “ON”)
E00522600608
Type 1
Type 2
If any of the doors or the rear hatch is not complete-
ly closed, this displays the open door or rear hatch.
If
the vehicle speed exceeds approximately 8 km/h
(5 mph) while a door is ajar, a buzzer sounds 4
times. This notifies the driver that a door is ajar.
CAUTION
l
Before moving your vehicle, check that
the warning lamp is OFF.
NOTE
l
In
order to prevent the battery from running
down, the lamp goes out automatically if you
leave the door open for a long time.
Refer to “Lamps (room lamps, etc.) auto-cut-
out function” on page 5-96.
Changing the function settings (when
the ignition switch is “ON”)
E00522700423
1. Stop the vehicle in a safe place.
Firmly
apply the parking brake and put the
gearshift lever into the “N” (Neutral) posi-
tion (M/T), the selector lever into the “P”
(PARK) position (CVT) or the gearshift lev-
er into the “P” (PARK) position (Twin
Clutch SST).
2. Lightly press the multi-information meter
switch a few times to switch the information
screen to the function setting screen. Refer to
Instruments and controls
3-18
3
To Next Page
Loading...
