3. Remove the bulb by pulling it out.
4. To
install the bulb, perform the removal
steps in reverse.
NOTE
l
When installing the lamp, insert tab (C) first
then align and insert tab (D).
Front room & map lamps*
E01009500019
When replacing the bulb, put the front room & map
lamps switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver
with a cloth over its tip into the notch of the
lamp assembly. Gently pry to remove the lens.
2. While
holding down the tab (A), pull out the
bulb.
3. To
install the bulb, perform the removal
steps in reverse.
NOTE
l
When
mounting the lens, align the tab (B) to
the hole on the vehicle body.
Rear room lamp*
E01004900278
When replacing the bulb, put the rear room lamp
switch into the “OFF” position.
1. Insert a straight blade (or minus) screwdriver
with a cloth over its tip into the notch of the
lamp assembly and pry gently to remove the
lens.
Maintenance
8-41
8
To Next Page
Loading...
