For quick demisting
1.
Set
the mode selection dial to the “
” posi-
tion.
2.
Set the blower to the maximum speed.
3. Set the temperature to the maximum temper-
ature position.
NOTE
l
While the mode selection dial is set to the
“
”
position, the outside air position will
be selected automatically.
l
To demist effectively, direct the air flow
from the side ventilators towards the door win-
dows.
l
For vehicles with the Auto Stop & Go
(AS&G) system, if the mode selection dial is
set to the demister position shown in the illus-
tration, the Auto Stop & Go (AS&G) system
will not operate and the engine will not stop
automatically even if the vehicle is stopped.
This is to ensure that good visibility is main-
tained.
Introduction of outside air
E00734900017
To
introduce air into the vehicle during hot weath-
er, set the air selection switch (A) to the outside po-
sition and set the temperature control dial to the po-
sitions shown in the illustration. Be sure to set the
temperature control dial all the way to the left. Se-
lect the desired blower speed.
NOTE
l
Turn
the mode selection dial clockwise and
air will flow to the leg area and the windscreen.
Manual air conditioning*
E00700500348
The
air conditioning can only be used while the en-
gine is running.
Control panel
E00700600479
A- Temperature control dial
B- Air selection switch
C- Blower speed selection dial
D- Air conditioning switch
E- Mode selection dial
F-
Rear window demister switch ® p. 3-58
Blower speed selection dial
E00700700164
Select the blower speed by turning the blower
speed selection dial clockwise or anticlockwise.
For pleasant driving
5-07
5
To Next Page
Loading...
