Mitsubishi Lancer Sportback - Coming Home Light

• Turn the combination headlamps and dip-
per switch to the “ ” or “ ” position.
• Turn
the ignition switch to the “ON” po-
sition.
l
It is possible to modify functions as follows:
• Except for vehicles for Russia, Kazakh-
stan and Ukraine, deactivating the wel-
come light function.
• Vehicles for Russia, Kazakhstan and Uk-
raine, activating the welcome light func-
tion.
• The headlamps can be set to come on in
the low beam setting.
For further information, we recommend
you to consult a MITSUBISHI MOTORS
Authorized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make
the adjustment. Refer to the separate own-
er’s manual for details.
Coming home light
E00529000324
This
function turns on the headlamps in the low
beam setting for about 30 seconds after the ignition
switch is turned to the “LOCK” position.
1. Turn the combination headlamps and dipper
switch to the “OFF” or “AUTO” position
(for vehicles equipped with the automatic
lamp control).
2. Turn the ignition switch to the “LOCK” posi-
tion. Also, if a key was used to start the en-
gine, remove the key from the ignition switch.
3. Within 60 seconds of turning the ignition
switch to the “LOCK” position, pull the turn
signal lever towards you.
4. The headlamps will come on in the low-
beam setting for about 30 seconds. After the
headlamps go off, the headlamps can be
turned on again in the low beam setting for
about 30 seconds by pulling the turn signal
lever towards you within 60 seconds of turn-
ing the ignition switch to the “LOCK” posi-
tion. To turn on the headlamps again after 60
seconds of turning the ignition switch to the
“LOCK” position, repeat the process from
step 1.
NOTE
l
While the coming home light function is op-
erating, perform one of the following opera-
tions to cancel the function.
• Pull the lever towards you.
• Turn the combination headlamps and dip-
per switch to the “
” or “ ” position.
• Turn
the ignition switch to the “ON” po-
sition.
l
It is possible to modify functions as follows:
• The time that the headlamps remain on
can be changed.
• The coming home light function can be
deactivated.
For further information, we recommend
you to consult a MITSUBISHI MOTORS
Authorized Service Point.
On vehicles equipped with MITSUBISHI
Multi-Communication System (MMCS),
screen operations can be used to make
the adjustment. Refer to the separate own-
er’s manual for details.
Instruments and controls
3-47
3
OG4E12E1