EasyManua.ls Logo

Mitsubishi Lancer Sportback - Page 221

Mitsubishi Lancer Sportback
433 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l
In
the following situations, the screen indica-
tion may be difficult to see. There is no ab-
normality.
Low light (nighttime)
When the light of the sun or the light
from a vehicle’s headlamps shines direct-
ly into the lens
l
If the camera is hot and is then cooled by
rain or a car wash, the lens can mist up. This
phenomenon does not indicate a malfunction.
l
It is not possible to fully see obstacles when
the lens is dirty. If the lens becomes contami-
nated by water droplets, snow, mud or oil,
wipe off the contamination, taking care not
to scratch the lens.
l
Please observe the following cautions. Ignor-
ing them could lead to a camera malfunction.
Do not subject the camera to physical
shock.
Do not apply wax to the camera.
Do not splash the camera with boiling wa-
ter.
Do not disassemble the camera.
Reference lines on the screen
Reference lines and upper surface of the rear bump-
er (A) are displayed on the screen.
l
Red line (B) indicates approximately 50 cm
behind the rear bumper.
l
Two Green lines (C) indicate approximately
20 cm outside of the vehicle body.
l
Short transverse lines (1 to 3) indicate dis-
tance from the rear bumper.
1- Approximately
at the rear edge of the rear
bumper
2- Approximately 100 cm
3- Approximately 200 cm
NOTE
l
When the vehicle is tilting because of the num-
ber of people in the vehicle, the weight and
positioning of luggage, and/or the condition
of the road surface, the lines in the view
from the rear-view camera may not be accu-
rately positioned relative to the actual road.
The reference lines for distance and vehicle
width are based on a level, flat road surface.
In the following cases, objects shown on the
screen will appear to be farther off then they
actually are.
When
the rear of the vehicle is weighed
down with the weight of passengers and
luggage in the vehicle.
A- Actual objects
B-
Objects shown on the screen
When there is an upward slope at the back.
A- Actual objects
B- Objects shown on the screen
l
The reference lines for distance and vehicle
width are intended to indicate the distance to
Starting and driving
4-64
4
OG4E12E1

Table of Contents

Related product manuals