EasyManua.ls Logo

Mitsubishi Lancer Sportback - Air conditioning switch

Mitsubishi Lancer Sportback
433 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
l
Disable automatic air control:
Even
when the air conditioning operates, the
air selection switch will not be automatically
controlled.
l
Setting change method
Hold down the air selection switch for about
10 seconds or more.
When the setting is changed, a sound is emit-
ted and the indication lamp flashes.
When the setting is changed from enable
to disable 3 sounds are emitted and the in-
dication lamp flashes 3 times.
When the setting is changed from disable
to enable 2 sounds are emitted and the in-
dication lamp flashes 3 times.
NOTE
l
The factory setting is “Enable automatic air
control.”
l
When the mode selection dial is turned to
”,
in order to prevent misting of the win-
dows the ventilator automatically switches to
outside air even if “Disable automatic air con-
trol” is set.
Air conditioning switch
E00701500840
Push the switch to turn the air conditioning on, the
indication lamp (A) will come on.
A sound will be made every time you push the
switch.
Push the switch again to switch it off.
CAUTION
l
When
using the air conditioning, the
idling speed may slightly increase as the
air conditioning compressor is switched
on/off automatically. While the vehicle
equipped with CVT is stationary, fully de-
press the brake pedal to prevent the vehi-
cle from creeping.
NOTE
l
If
a problem is detected in the air condition-
ing system, the air conditioning operation in-
dication lamp (A) blinks. Press the air condi-
tioning switch once to turn it off, then once
more to turn it back on. If the air condition-
ing operation indication lamp (A) does not
blink for a while, there is nothing wrong. If it
starts to blink again, we recommend you to
have it checked.
l
Sometimes, for example after using a high-
pressure car wash, the condenser can get wet,
and the operation indication lamp (A) blinks
temporarily. In this case there is nothing
wrong. Wait a while, press the air condition-
ing switch once to turn the system off, then
once more to turn it back on. Once the water
evaporates, the blinking will stop.
Operating the air conditioning system
E00701800380
Heating
Set
the mode selection dial to the
position
and set the air selection switch (A) to the outside po-
sition.
For pleasant driving
5-09
5
OG4E12E1

Table of Contents

Related product manuals