The settings mode can be toggled by press-
ing
the UNLOCK switch. The mode can be
confirmed from the number of times the buz-
zer sounds.
Number of
times the buz-
zer sounds
Security alarm settings mode
1 Alarm inactive
2 Alarm active
6. Any
of the following operations can be used
to terminate the system settings change mode.
• Releasing
the windscreen wiper and
washer switch.
• Closing the driver’s door.
• Inserting the key into the ignition
switch.
• Placing the lamp switch in any posi-
tion other than “OFF”.
• Allowing 30 seconds to pass without
making any changes to the settings.
• Push the ignition switch to the
“LOCK” (PUSH ON) position (Vehi-
cles with keyless operation system).
NOTE
l
If anything with regard to making changes to
the security alarm system settings is hard to
understand, please consult your
MITSUBISHI MOTORS Authorized Service
Point.
l
Avoid leaving valuable items inside the vehi-
cle even when the security alarm system has
been set to the “active” mode.
Setting the system
E00301700877
Follow the procedure below to set the system to the
system armed mode.
1. Turn
the ignition switch to the “LOCK” posi-
tion. If you started the engine with the key,
remove the key from the ignition switch.
2. Exit the vehicle and close all of the doors,
rear hatch and bonnet.
3. Press the LOCK switch (A) on the remote
control switch of the keyless entry system or
the keyless operation system, the driver’s or
front passenger’s door lock/unlock switch
(B), or the rear hatch LOCK switch (C) in or-
der to lock all the doors and rear hatch.
To Next Page
Loading...
