If the measured room temperature is out of
0°C to 40°C range, the room temperature
display blinks.
When the indoor unit is operating, the room tem-
perature display shows the actual room tempera-
ture (18°C) below and the set temperature (20°C)
above as shown in the gure to the right. The meas-
urable temperature range is from 0°C to 40°C.
When the wireless remote controller is installed on a bracket, room temperature might
not be accurate being affected by the wall temperature.
Perform a test run and place the remote controller where the room temperature can
be correctly detected.
15
<Inactive>
<Active>
6.6. Automatic Zone No. Display (Mode No. 5)
Set the mode no. to “5”.
When the automatic zone no. display is ac-
tive, a zone number assigned to the remote
controller is displayed for 3 seconds after
temperature setting.
Press or button to select between "
" and or , and press button to
save setting.
Inactive :
" ".
Active :
The zone no. ( or ) as-
signed to the remote controller
is shown.
To Next Page
Loading...
Need help?
General
