Mitsubishi PLK-E03BT User Manual

－19－
(6) Set sewing speed by pressing A key on the setting panel. Then LCD shows like
below.
(7) Insert the sewing material under the work holder (NO.3) then, step on the foot switch
(NO.2) lightly. The work holder comes down to press the sewing material.
(8) When the foot switch (NO.2) is depressed further deeper from the lightly depressed
position, stitching is initiated begging with home position.
NOTE The sewing material will be released after the foot switch (NO.2) becomes free again
before starting the machine.
(9) After finished the sewing, the work holder (NO.3) is lifted automatically then, the sewing
material is released.
★In case of (5)., if the foot switch (NO.2) strongly and rapidly, the machine will start sewing
immediately after work holder goes down.
Cution
LED4 LED3
H
LED1 LED2 LED5
F
A
B C D
Changeover to normal mode
function
The setting value displayed in LED 5 is
validated, and the normal mode is
returned to.
Setting value changeover function
(decrement)
With each press, the LED 5 display (setting
value
)
will decrement b
y
one.
(
0
,
9 ... 2
,
1
,
0
,
9
)
Key operation invalid
Nothing will occur even if the
ke
y
is o
p
erated.
Setting value changeover function
(increment)
With each press, the LED 5 display (setting
value) will increment by one.(0,1, ... 8,9,0,1)
Setting value changeover function
(increment)
With each press, the LED 5 display (setting
value
)
will increment b
y
one.
(
0
,
1 ... 8
,
9
,
0
,
1
)

Mitsubishi PLK-E03BT Specifications

General

Brand	Mitsubishi
Model	PLK-E03BT
Category	Sewing Machine
Language	English