－32－
7-18. Adjustment of the mechanical home position
[NOTE] The mechanical home position is fixed at the center of the sewing area when the
sewing machine is shipped from the factory. However, it can be moved within the area
covered with diagonal lines.
(1) Turn the power switch ON and cancel the sewing area limit with the setting panel of the
control box. For this cancellation, at the normal mode condition of the setting panel, push
(2) F key (NO.1) then, press ↓ key (NO.2) and A key (NO.3) at the same time for
more than 2 seconds. The LED1,2 and 3 shows [A,L,C].
(3) Press C (NO.4) or D (NO.5) key to set the LED 4 and 5 to [O,N].
(4) Press H key to return to the normal mode.
[NOTE] If do not cancel the sewing area limit, shifting the mechanical home position make the
effective sewing area narrower than the original.
(1)Center of sewing area
(2)Standard home position
(3)Adjustable
3
15 10
30
1
5
3
0
1
2
6
.
7
LED4
LED3
H
LED1 LED2 LED5
Ａ
ＡＡ
Ａ
B C D
F
2
1
4 5
To Next Page
Loading...
Need help?
General
