<Applicable models>
PFD-P250 500VM-E
<Notes>
• Thoroughly read the "Safety Precautions" in the installation manual.
• Provide the replacement after turning off the main power of the unit.
• It is recommended to read the data book before starting the replacement.
<Required tools>
General tools (Phillips screwdriver, Socket wrench, Hex key, Plastic hammer, Scale, etc.)
Torque wrench, Screw lock, Tension gauge, Pulley puller, Bearing puller, and Pallet jack
<Instructions>
1. Removing the motor
(1) Disconnect the motor wiring.
(2) Remove the Bolt 1 (two places) and Bolt 2 (one place) on the motor.
Bolt 1: M10
Bolt 2: M12
To Next Page
Loading...
