5 - 81
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid ( : Invalid, : Valid)
MR-
H-BN
MR-
H-BN4
MR-
J2-B
MR-
J2S-B
MR-
J2-Jr
MR-
J2M-B
Value set with sequence program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
50 to 1000 100 30155 30255 30355 30455
0
Encoder output
pulse direction selection
H
00
1: is used to set up the setting
value.
(Hexadecimal)
0000
H
30160 30260 30360 30460
Notch filter frequency
0
Notch depth selection
selection
1: is used to set up the setting
value.
(Hexadecimal)
H
0000
H
30161 30261 30361 30461
2: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75), then switch it on
again to make that parameter setting valid.
3
: Don't use to the parameter (normal). Don't change setting value "Default value" by any means.
To Next Page
Loading...
