Mitsubishi QJ71MT91 - Page 287

Index - 3 Index - 3
SD ............................................................... 6- 5
Local slave station port No............................ 7-17
[M]
Master function............................................... 5- 1
Master function performance .....................App- 2
Max. number of modules ............................... 2- 1
Maximum node-to-node distance .................. 3- 1
Maximum number of connections.................. 3- 1
Maximum number of parameter settings....... 8- 3
Maximum segment length.............................. 3- 1
MODBUS
R
device
MODBUS
R
device assignment function ... 5-11
MODBUS
R
device assignment parameter
error code storage area........................... 11-14
MODBUS
R
device assignment parameter
setting result storage area....................... 11-14
MODBUS
R
device assignment parameter
starting method.......................................... 6-13
MODBUS
R
device assignment parameters
................................................................... 7-23
MODBUS
R
device assignment parameters
details......................................................... 7-26
MODBUS
R
device sizes ............................ 7-25
MODBUS(R) device assignment parameter
screen ........................................................ 8-35
MODBUS
R
device assignment parameter
setting ............................................................. 9- 7
I/O signals for setting.................................. 9- 7
Setting method ........................................... 9- 7
Setting precautions.................................... 9-10
Timing charts for setting ............................. 9- 8
MODBUS
R
extended file register assignment
....................................................................... 7-31
MODBUS
R
extended file register size .......... 7-31
MODBUS
R
standard functions....................... 4- 1
Mask write register .................................... 4-19
Read coils ................................................... 4- 6
Read discrete inputs................................... 4- 7
Read file record ......................................... 4-15
Read holding registers ............................... 4- 8
Read input registers ................................... 4- 9
Read/Write multiple registers .................... 4-20
Write file record.......................................... 4-17
Write multiple coils..................................... 4-12
Write multiple registers.............................. 4-14
Write single coil.......................................... 4-10
Write single register................................... 4-11
MODBUS
R
/TCP setting ................................7-17
Module ID.......................................................7-20
Monitor/test ....................................................8-17
Multiple CPU system ......................................2- 3
[N]
Network configuration .....................................2- 4
Number of cascade connection stages..........3- 1
Number of errors occurred ..........................11-16
Number of occupied I/O points.......................3- 1
Number of routers set ....................................7-13
Number of routers that can be set..................3- 1
[O]
Online change enable/disable setting ...........6-13
Operating environment ...................................8- 4
Operation mode setting .................................6-11
[P]
Parameter setting method ..............................7- 1
Parameter setting procedures ........................7- 2
Parameter types..............................................7- 1
Part names......................................................6- 4
PDU formats....................................................4- 4
Performance specifications ............................3- 1
PING test............................................. 8-29,11-41
Preferred node specification..........................7-18
Preferred node specification: IP address ......7-18
Preferred node specification: TCP
connection......................................................7-18
Pre-operational procedures and setting.........6- 2
Processing time ......................................... App- 2
Program example
Program example for use in normal
system configuration ..................................9-11
Program example for use in MELSECNET/H
remote I/O network ....................................9-29
[Q]
QJ71MT91 buffer memory assignment ........7-32
QJ71MT91 status confirmation ...................11-10
[R]
Relationship between COM.ERR. LED and
I/O signals ....................................................11-40
Relationship between PING test and I/O
signals ..........................................................11-46
Repeat interval timer value............................7-20