-
9
-
❚
7. SLEEP TIMER OPERATION
The operation stops at the specified
time.
1,2
[EXAMPLE] If you would like to stop the operation 12 hours later
1.
Press SLEEP button.
The OFF TIMER indicator LED lights up. “1H” is displayed.
The timer/check indicator LED lights up on the remote control signal receiver.
2.
The display changes as shown below each time the SLEEP
button is pressed.
The display changes as follows: 1H ➞ 2H ➞ 3H (one hour increment) ➞ 10H ➞
11H ➞ 12H ➞ Sleep timer reset ➞ 1H ➞ 12H.
By stopping at 12H, operation stops after 12 hours.
●
Cancellation
•
If you press the SLEEP button or CANCEL button, the timer display disappears
and the timer is canceled.
•
If you press the RUN/STOP button before the specified time is reached, the
timer display disappears and the timer is canceled.
●
Changing the set time
•
Press SLEEP button to set again.
❚
8. PROGRAM TIMER OPERATION
By setting both ON TIMER and OFF
TIMER, the settings turn into
PROGRAM timer mode. Operation
and stopping can be performed at
the same time every day by setting
program timer once.
1
2
1.
Set ON TIMER.
Press ON TIMER button and set the time with or button.
Press SET button.
2.
Set OFF TIMER.
Press OFF TIMER button and set the time with or button.
Press SET button.
Both ON TIMER and OFF TIMER are displayed. The direction of arrow mark
changes depending on the status of operation.
(stop) (operating)
If the same time is set for the ON TIMER and OFF TIMER,
is displayed,
which makes the program timer stop the operation at the same time every day.
●
Cancellation
•
Press CANCEL button to turn off the PROGRAM timer display and timer is
canceled. (Operation condition is kept as before the button is pressed.)
•
If ON/OFF button is pressed during TIMER operation, TIMER display turns off
and the TIMER is canceled. The air conditioner stops operating.
●
Changing the set time
•
Press OFF TIMER button or ON TIMER button to set again.
PJZ012A128_EN.indd 9PJZ012A128_EN.indd 9 11/10/2016 6:53:22 PM11/10/2016 6:53:22 PM