2 Setup
9
No. 99MBC109B
2.3.2 Connecting Cables for External Equipment
You must supply USB, RS-232C, and I/O connector connecting cables for
connecting external equipment.
Use a Mitutoyo-approved connecting cable for RS LINK connections.
Tips
• For details about USB connecting cables, see "5.2 USB Communication Function"
(page 35).
• For details about RS-232C connecting cables, see
"5.3 RS-232C Communication
Function" (page 36).
• For details about I/O connecting cables, see
"5.5 I/O Connector Terminal Function"
(page 42).
• For details about RS LINK, see
"5.4 RS LINK Function" (page 40).
2.3.3 Connection Procedure
• Always turn off the power switch of this product while making connections.
• Do not run the power cable and Linear Gage connecting cable through a cable duct
together with other power lines.
• Secure the power cable and connecting cables for external equipment to your equipment
with a cable tie, cable holder, etc.
Be sure to connect this product to ground. If this product is not grounded, it
will be more susceptible to electrical noise.
Make connections as shown in the gure below.
Linear Gage
input connector
Linear Gage
AC adapter
DC jack
Grounding terminal
Grounding wire
(Sold separately)
Power switch
I: On
O: Off
To Next Page
Loading...