Mitutoyo EH-101P - Operation Check

2 Setup
10
No. 99MBC109B
2.4
Operation Check
Check the cable connections with the following procedure to conrm that the
connections are correct.
1
Turn on the power switch.
» The Counter enters the stand-by
state.
2
Press [SEL]/[CE].
» The Counter changes to the Counter
display.
Tips
EH-102Z will enter the origin-detection waiting state. To change to the Counter display,
push in the contact point of the Linear Gage to make it pass over the origin.
3
Check that the counter value is shown on the Display.
4
Check that the counter value on the Counter changes by moving the contact
point of the Linear Gage up and down.