4 Basic Operations
34
No. 99MBC109B
4.8
Registering, Reading Out, and Clearing
the Memory
The following procedures explain how to register, read out, and clear the
memory.
Tips
• This operation is available when the set value for parameter number 06 is 3 (memory
display).
• When BANK1 is selected, the current value of INPUT A will be displayed on Display A.
When BANK2 is selected, the current value of INPUT B will be displayed on Display A.
For details about BANK switchover, see
"4.2 Switching the Displayed BANK (2-Axis
Models Only)" (page 25).
z
Procedure to register the memory
1
Press [B_ZERO].
»
The current value in Display A is stored in Display B.
z
Procedure to read out the stored data
1
Press and hold [SEL] to select Display B.
Tips
For details, see "4.1 Switching Between Display A and B (2-Axis Models Only)"
(page 25).
2
Press [MODE] (switch to Peak mode).
»
Each time you press [MODE], the displayed memory value will cycle through
maximum value
→
minimum value
→
TIR value.
z
Procedure to clear the memory
1
Press and hold [SEL] to select Display B.
Tips
For details, see "4.1 Switching Between Display A and B (2-Axis Models Only)"
(page 25).
2
Press [P.SET].
»
The value in memory (maximum value/minimum value/TIR value) will be cleared,
and then the current value in Display A will be displayed.
To Next Page
Loading...