As the touch signal probe of the digimatic height gage
of the probe triggers data output to the Digimatic
has
a
self-contained ball radius compensation macha-
Data Processor (DP-1 or DP-2) tied with in the output
nism, you do not have to worry about the ball radius
connector for automatic data printing.
of the probe when reading the display value even in
external or internal width measurement and height
.For details of touch signal probe, please refer to the
measurement
as
well. Furthermore, the touch signal
operation manual No. 201
5.
4.
1
Example of measurement
by
a probe
.Be sure to turn off the power before connecting the
.A
50mm(2") gauge block is used for determing the
touch signal probe. origin point.
Fig.
11
.Circled figure shows the
probe
position
and relative opera-
tion.
To Next Page
Loading...
