Mitutoyo HDM 192 Series - Understanding Display Signs and Symbols

@ When the stylus is applied to the measured
surface, the display holds the value of
C with the
blinking of
H sign.
Fig. 11
@ To take measurement of the dimension D, apply
the stylus to the measured surface. The display
holds the value of
D with the blinking of H sign.
@ Release the stylus from the workpiece and press
the
/ key so that you can take measurement
@ Have the stylus contacted with the measured
surface on the top. The display holds the value of
D with the blinking of H sign.
MM
- -- - - -- .-
INCH
..,
- - - - . - -
\I,
H
,a\
INC H
,A\
I NC
- I b-l b-l 1-f
- b7 LI )7 b-f )-f in
/ LI. LI LI mm Lf. I LI Ll LI
-
ABS
. --.-
ABS
-
. r, ABS 1 r- --.-,-i
- -
H
<a\
H
I'\
ABS
I 3~ n~f
b- b7 b7 b-f b-f in
I L -I.U Umm '
3. LI LI LI LI