21
2 Basic Measuring Methods
No. 99MAF600B
2.2 Measuring the Height
Measure the height. Height measurements are divided into "top surface height measurements", where
the top surface of the workpiece is brought into contact with the stylus, and "bottom surface height mea-
surements", where the bottom surface is brought into contact with the stylus.
This section explains both measurement procedures using the surface plate as the origin (ABS mea-
surement system).
s1
s1
Origin
(ABS measure
-
ment system)
Origin
(ABS measure
-
ment system)
Bottom surface height measurementTop surface height measurement
1
Set the surface plate as the origin (ABS measurement system).
For details about the setup, see "2.1.1 Setting the Origin and the Reference" on page 12.
2
Turn the probe unit up/down wheel, and slowly bring the stylus into contact with surface s1
until there is a "beep" sound (keep the stylus in contact with the surface).
y For top surface height measurements
» When the measurement is complete,
[H] and the measurement value are
displayed on the LCD.
s1
y For bottom surface height measurements
» When the measurement is complete, [H]
and the measurement value are dis-
played on the LCD.
It will be automatically output at the same
time to the connected external device.
s1
3
Press [HOLD DATA].
» The displayed measurement value is
held. (Press [HOLD DATA] again to
release the hold.)
A video about measuring the
height can be viewed.
To Next Page
Loading...
