Mitutoyo QM-Height QMH-350BX - Calculating the Difference between the Current and Previous Measurement Values

34
3SpecicUsageApplications
No. 99MAF600B
y Calculatingthedi󰀨erencebetweentwomeasurementvaluesstoredinmemory
Thetwomeasurementvaluesarestoredintheproduct'sinternalmemory,andthenthedi󰀨erence
is calculated.
Thisisappropriateforcalculatingthedi󰀨erencebetweenmeasurementvalueswhentheprevious
two methods cannot be used.
For details, see
"3.1.3CalculatingtheDi󰀨erencebetweenTwoMeasurementValuesStoredin
Memory" on page 37.
3.1.1 CalculatingtheDi󰀨erencebetweentheCurrentandPrevious
MeasurementValues
Intheregularcondition,thedi󰀨erencebetweenthecurrentmeasurementvalueandthepreviousmea-
surement value is displayed in the bottom row of the LCD.
Thissectionexplainstheprocedureforcalculatingthedi󰀨erencebetweenmeasurementvalues(s2–s1,
s3–s2) when the height is measured in the order of s1, s2, s3 after the surface plate is set as the origin
(ABS measurement system) as shown below.
s3
s2
s3 - s2
s2 - s1
s1
Origin
(ABS measurement system)
1
Set the surface plate as the origin (ABS measurement system).
For details about the setup, see "●Settingthesurfaceplateastheorigin"onpage13.
2
Measure the height of s1.
For details about measuring height, see
"2.2 Measuring the Height" on page 21.
» The measurement value for s1 is displayed.
3
Measure the height of s2.
» The measurement value for s2 is displayed in the top row,
andthedi󰀨erencebetweens2ands1isdisplayedinthe
bottom row.