20
2 Basic Measuring Methods
No. 99MAF600B
5
Measure the bottom surface of the ball diameter calibration block.
1 Move the ball diameter calibration block (or main unit), and move the stylus to the following position near the
ball diameter calibration block.
2 Turn the probe unit up/down wheel, and slowly bring the stylus into contact with the bottom surface of the
ball diameter calibration block until there is a "beep" sound.
2
1
2
» The probe diameter calibra-
tion is complete.
Tips
• The dimensions of the ball diameter and the calibrated value of the probe diameter may not match exactly
due to bending of the stylus.
• The moment the beep sounds, the displayed value may appear to jump. The calculation of the ball's diam-
eter will then be displayed.
6
Press [ENTER].
» The ball diameter setup is complete.
To Next Page
Loading...
