Mitutoyo QM-Height QMH-600AX - Safety Precautions

ii
No. 99MAF600B
Safety Precautions
Read these "Safety Precautions" thoroughly before operating the product to use it properly.
These safety precautions include such information as to prevent injury to the operator and other per
-
sons, damage to property and product defects. Be sure to observe these precautions carefully.
WARNING
• Donotdisassembleormodifythisproduct.Doingsocanresultinreorelectricshock.
• Donotplacecontainerswithwater,suchasowerpots,nearthisproduct.Ifwatergetsintothe
device,areorelectricshockmayoccur.Ifwaterdoesgetintothedevice,turno󰀨thepower,
andcontactus.Continuingtousethedevicemayresultinareorelectricshock.
• Do not use the device in areas where volatile gases may be released. Doing so can result in a
re.
CAUTION
• This product is heavy. Do not allow it to be lifted or moved by only one person.
• Do not place the product on an unstable surface. It may fall or topple over, causing an injury.
• Do not charge or disassemble the accompanying batteries. They may short circuit.
• This product is heavy. Wear safety shoes. Slippers must not be worn when transporting or in-
stalling the product.
• Wheninstallingtheproductonasurfaceplate,becarefulnottopinchyourngerswiththebase.
• The product may cause injury if it falls down or over. Handle with care.
NOTICE
Do not apply an external voltage to the product with a device such as an electric engraver. Doing so
may lead to damage or malfunction.
• If the device will not be used for an extended period of time, remove the batteries. Battery leak-
age can damage the device.
• Only use LR6 (AA alkaline) or Ni-MH (nickel metal hydride) batteries.
Handle the batteries according to their instructions.