Mitutoyo QM-Height QMH-600AX - Page 43

29
2 Basic Measuring Methods
No. 99MAF600B
2 While keeping the probe unit up/down wheel
stationary, move the workpiece or the main
unit so the stylus moves and passes through
the highest point (there will be a beep sound,
and the highest point will be automatically
detected).
» The measurement of the highest
point is complete, and the mea-
surement value (diameter) will be
displayed.
It will be automatically output at
the same time to the connected
external device.
y For manual termination
1 While keeping the probe unit up/
down wheel stationary, move the
workpiece or the main unit so the
stylus moves left/right and passes
through the highest point.
» The counter value will change
according to the movements, and
the value will be held when the
highest point is detected.
2 Press [ENTER]. » The measurement of the highest
point is complete, and the mea-
surement value (diameter) will be
displayed.
It will be automatically output at
the same time to the connected
external device.
Tips
• Iftheprobeunitup/downwheelisdi󰀩culttosecure,tightentheclampscrew.
• A video about the outside diameter measurement (manual termination) can be viewed from
here.
6
To continue measuring another outside diameter, press [ENTER];tonishmeasuringpress[CANCEL].