Mitutoyo QM-Height QMH-600BX - Page 28

14
2 Basic Measuring Methods
No. 99MAF600B
●
Setting a position other than the surface plate as
the origin
As an example, the procedure for using a 25 mm gauge block
is explained below (setting value: +025.000).
Tips
Height measurements near 25 mm are more accurate when compared to when the surface plate is set as the
origin.
1
Press [PRESET].
» The preset value from the previous occasion is displayed
(initial value: +000.000).
2
Press [→] to make [+] blink.
If[-]isdisplayed,press[↑]or[↓]tochange
the display to [+].
» [+] will blink.
3
Repeatedly press [→]untilthevalueinthetensplaceashes.
» Thevalueinthetensplacewillash.
4
Press [↑] or [↓] to display [2].
A video about the setup can
be viewed.