Mitutoyo QM-Height QMH-600BX - 3.3 Setting Scanning Termination Method

44
3SpecicUsageApplications
No. 99MAF600B
3.3 Setting the Termination Method of Scanning Measurements
When measuring an inside or outside diameter using a scanning measurement, set the termination
method of the scanning measurement (automatic termination or manual termination). [Auto] (automatic
termination) is the default setting.
1
Press [MODE].
» Characters and icons will be displayed in the bottom row
of the LCD.
2
Press [Outside diameter measurement] and select the icon for [Probe settings].
M1 M2
3
Press [←]or[→]todisplaythefollowingscreen.
» Depending on the current setting, [Auto] (automatic
termination) or [ENTER] (manual termination) will be
displayed.
4
Press [↑]or[↓]andselecttheterminationmethodofthescanningmeasurement([Auto]or[ENTER]).
Selections Termination method
[Auto] The lowest point and highest point will be detected automatically, a beep sound will
be made, and the scanning measurement will terminate automatically.
[ENTER] Press [ENTER] to manually terminate the scanning measurement.
5
Press [ENTER].
» The setup is complete and the regular condition will be
restored.