Mitutoyo QM-Height QMH-600BX - Page 40

26
2 Basic Measuring Methods
No. 99MAF600B
2 While keeping the probe unit up/down wheel
stationary, move the workpiece or the main
unit so the stylus moves and passes through
the highest point (there will be a beep sound,
and the highest point will be automatically
detected).
» The measurement of the
highest point is complete,
and the measurement value
(diameter) will be displayed.
It will be automatically output
at the same time to the con-
nected external device.
y For manual termination
1 While keeping the probe unit up/
down wheel stationary, move the
workpiece or the main unit so the
stylus moves left/right and passes
through the highest point.
» The counter value will
change according to the
movements, and the value
will be held when the highest
point is detected.
2 Press [ENTER]. » The measurement of the
highest point is complete,
and the measurement value
(diameter) will be displayed.
It will be automatically output
at the same time to the con-
nected external device.
Tips
• Iftheprobeunitup/downwheelisdi󰀩culttosecure,tightentheclampscrew.
• A video about the inside diameter measurement (manual termination) can be viewed from
here.
6
To continue measuring another inside diameter, press [ENTER];tonishmeasuringpress[CANCEL].