How to install the battery of remote controller
Open the battery door, install 4" AA batteries into the battery compartment according to the given polarity
and then close the battery compartment.
t
*Insert batteries with correct polarity.
*Non rechargeable batteries are not to be charged; the transmitter need 4*AA batteries for
work.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
*Rechargeable batteries are to be removed from the aircraft before being charged.
*Rechargeable batteries are only to be charged under adult supervision.
*Exhausted batteries are to be removed from the aircraft.
*The supply terminals are not to be short-circuited.
How to connect the signal of the aircraft with the
remote controller
Step 1: Keep pressing the red button "13 and turn on the remote controller
as Pic. 1).
The remote controller makes 2 beep souncs
:
and the inaicator light keeps flashing; the remote
controller is under signal connection status.
Step 2: Power on the aircraft. The aircraft will make beep sounds with front and rear lights flashing and
will automatically link to the remote controller. Once the remote controller sends out a long beep
sound and the indicator light of the remote controller turns from flashing to solid on and the
signal icon "
" is shown on the LCD screen, it means that signal connection is succeeded.
Pic_ 1
Pic. 2
Pic. 3
•
Signal connection is done once for all if the remote controller is not linked to other aircraft.
•
Set the connection one by one to avoid signal connection error.
-8-
How to install the battery of remote controller
Open the battery door, install 4" AA batteries into the battery compartment according to the given polarity
and then close the battery compartment.
t
*Insert batteries with correct polarity.
*Non rechargeable batteries are not to be charged; the transmitter need 4*AA batteries for
work.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
*Rechargeable batteries are to be removed from the aircraft before being charged.
*Rechargeable batteries are only to be charged under adult supervision.
*Exhausted batteries are to be removed from the aircraft.
*The supply terminals are not to be short-circuited.
How to connect the signal of the aircraft with the
remote controller
Step 1: Keep pressing the red button "13 and turn on the remote controller
as Pic. 1).
The remote controller makes 2 beep souncs
:
and the inaicator light keeps flashing; the remote
controller is under signal connection status.
Step 2: Power on the aircraft. The aircraft will make beep sounds with front and rear lights flashing and
will automatically link to the remote controller. Once the remote controller sends out a long beep
sound and the indicator light of the remote controller turns from flashing to solid on and the
signal icon "
" is shown on the LCD screen, it means that signal connection is succeeded.
Pic_ 1
Pic. 2
Pic. 3
•
Signal connection is done once for all if the remote controller is not linked to other aircraft.
•
Set the connection one by one to avoid signal connection error.
-8-
To Next Page
Loading...
