9
Operating
For the new operator
The Pulsar Cutter is designed to cut long grass and scrub land with small trees or saplings 1
1/4 inch dia. The cutter will work best on dry conditions. When cutting damp or longer grass,
use slower travel speed and you my need to frequently clean the underside of the cutter deck.
Power to the blades is provided by the tractor through a PTO Shaft and Gearbox.
The cutter is designed for a 540 RPM PTO speed and will give the best performance at this
speed.
Many features in this cutter are the result of suggestions made by customers like you.
By following the operating instructions in conjunction with a good maintenance program, your
Pulsar Cutter will provide you with many years of service.
To Operate:
Attach the cutter to the tractor 3ph. Ensure the deck is level to the ground by adjusting the right
hitch arm adjustment and the top link until the deck is level.
Cutting height is controlled by adjusting the rear wheel height.
Starting the Mower:
With the cutter slightly raised from the ground. (wheel may be off the ground 3-6 inches)
Run the engine at a slow speed and slowly engage the PTO.
Slowly bring the engine to PTO speed. Do not exceed rated speed.
Lower the cutter to the ground and proceed to cut.
Ground Speed:
Travel speed can vary between 1 and 4 mph (1.5 and 6km/h) depending on the grass and
terrain conditions. It is the responsibility of the operator to note the conditions of the job being
done and to set the speed to obtain a quality cutting job while maintaining control of the equip-
ment.
The speed can be increased for lighter cutting conditions.
Decrease your speed if the cut is ragged and uneven, or uncut patches.
Transport on Road - Be Safe, Be Seen!
When driving on the road please follow all regulations. Use lights, reectors, SMV sign as re-
quired by law.
To Next Page
Loading...