MK Martin PULSAR PLUS - Decal Location

7
Decal Location
THIRD ANGLE PROJECTION
5
4
3
1
Folder
DWG. NO.
REV
Model
SCALE 1:4
SHEET 1 OF1
DATE DRAWN
MATERIAL
Pulsar Plus Logo
February-01-16 9:23:41 AM
DESCRIPTION
Pulsar Decal for Rotary Cutter & Finishing Mower
S:\Solidworks\Solidworks_Elo\Decal\
Weight(lbs.) Width Height Length
sq. inch "iERP_Stock_QPA@Default@Pulsar Plus Logo.SLDPRT"
Blank Size Unit of Measure
ITEM ID.
decalPulsar
Config ID
Default
DIMENSIONS ARE IN INCHES
TOLERANCES NON SPECIFIED:
FRACTIONAL 1/64
BEND 1.0
TWO PLACE DECIMAL 0.01"
THREE PLACE DECIMAL 0.002"
Notes
DO NOT SCALE DRAWING
THIRD ANGLE PROJECTION
1
2
3
4
5
6
7
8
10
9
11
5
4
3
1
Folder
S:\Solidworks\Solidworks_Elo\Cutter\Pulsar\Pulsar Plus 72\52990.SLDASM
DWG. NO.
REV
Model
SCALE 1:48
SHEET 3 OF3
DATE DRAWN
MATERIAL
52990
December-18-15 12:58:30 PM
DESCRIPTION
72 Pulsar Plus Cutter
S:\Solidworks\Solidworks_Elo\Cutter\Pulsar\Pulsar Plus 72\
Weight(lbs.)
0
Width Height Length
0 0 723.15 0
Blank Size Unit of Measure
ITEM ID.
52990
Config ID
52990
DIMENSIONS ARE IN INCHES
TOLERANCES NON SPECIFIED:
FRACTIONAL 1/64
BEND 1.0
TWO PLACE DECIMAL 0.01"
THREE PLACE DECIMAL 0.002"
Notes
DO NOT SCALE DRAWING
#1 - Before any operation of main-
tenance a/o adjustment, stop, brake
the tractor on level ground, lower the
machine to the ground and read the
instruction manual.
#2 - DANGER. Sharp objects could
be thrown. Keep safe distance from
the machine
#6 - DANGER of possible shearing
of limbs.
Do not remove the protec-
tive shields unless all moving parts
of the machine have reached a
complete standstill.
#3 -
Grease
#4 - DANGER of possible shearing
of limbs. Keep a safe distance from
the machine while it is working.
#5 - DANGER of being caught by
the PTO shaft. Do not go near the ro-
tating members of the machine while
in operation.
#11 -
Serial plate
#8 - Before operating machine,
carefully read the instruction manual
#10 - DANGER of being crushed.
Do not get between the tractor and the
machine.
#9 - MK Martin
Made in Canada
#7 - Pulsar
decal - x2