MK MK-2000 - Safety Label Locations

13
The MK-2000 Electric Saws is equipped with a number of safety decals provided for operator safety
and maintenance information. Should any of these decals become unreadable, replacements can be
obtained by calling (800) 262-1575.
OPERATION & SAFETY DECALS
MK-2000 ELECTRIC SAW SAFETY
Decal Location Description
A Motor - Back Warning - Silica
B Cutting Head Warning - Read Manual
C Motor - Side Caution - Ground Fault Circuit Interrupter
D Motor - Side Caution - Receptacle Water Pump
E Motor - Back Service/Warranty
F Blade Guard Caution - Guards in Place
F Belt Guard Caution - Guards in Place
G Blade Guard Warning - Replace Blade Guard
H Motor - Back Notice - Extension Cord
I Motor - Back QR Code for Manuals
Part # 154398
Part # 155587 (2)
Part # 155588
WARNING
In the event of blade
failure, replace
blade guard
immediately.
!
Part # 164202
Part # 170480
Scan for manuals
WARNING
•Thisequipmentmayproducedustormistscontaining
 crystallinesilica.
•Silicaisabasiccomponentofmasonry,concrete,and
 othermaterials.
•Repeatedand/orsubstantialinhalationcancause
 seriousorfatalrespiratorydiseasesincludingsilicosis.
•RespirablecrystallinesilicaislistedbyCaliforniaand
 otherauthoritiesasasubstanceknowntocausecancer.
•Employdustcontrolsandprotectionper
 OSHA/NIOSH/MSHA.
!
DO NOT operate
this equipment
before reading the
owner’s manual.
WARNING
!
Part # 154822Part # 155678
Receptacle is for water
pump only.
125V .6 amps max.
!
CAUTION
!
CAUTION
This saw is to be used
with a Ground Fault
Circuit Interrupter.
CAUTION
DO NOT
operate without
guards in place.
!
Part # 155038
SERVICE OR
WARRANTY
FOR INFORMATION ON
PLEASE CALL
1-800-474-5594
Part # 155672
NOTICE
Most Motor Problems are
caused by Low Voltage from
Improper Extension Cords.
See Owner’s Manual for
Extension Cord Selection.
!
A
E
F
G
H
I
B
C D
F
A
FH
D
C
G
E
I H
B